  |
SECORR 300 |
   |
SeCorr 300 -Digital leak locating correlator |
Click on any image to
enlarge
 |
The SeCorr® 300 is Sewerin's new fully digital correlator offering
unprecedented performance in finding water leaks even on plastic pipes
and trunk mains.
The fully digital signal processing and data transmission largely eliminate
the limitations experienced with conventional analogue correlators.
Notebooks, Toughbooks and desktop PCs can be used to analyse the measurements.
USB connections ensure the system can be easily connected to all these
computers.
The SeCorr® 300 system offers you the best chance of finding those difficult
to locate water leaks, even under the most difficult of conditions where
other conventional correlators have reached the end of their detection
limits. |
SECORR
300 FEATURES |
|
The Digital radio transmitter unit |
|
The radio transmitter RT 300
is mounted on a tripod during correlation offering optimum radio performance.
If the radio transmitter is out of transmission range of the base station
the water leak noise is stored in the transmitter's memory and transmitted
to the receiver as soon as the radio connection is re-established. |
 |
Thanks to a microphone holder on the tripod,
the transmitter and microphone can easily be carried in one piece.
The user can listen to the current noise through headphones, allowing
them to assess the volume of the noise, frequency filters can set directly
at source to render the sound clearly for your ears and the particular
leak. Using the filters it is possible to hear only the frequency range
where the water leak noise is best heard by you. |
|
The Radio Receiver |
 |
The RX 300 receiver receives
signals from the transmitter and relays them to the PC via a USB cable.
The cable can be connected to any computer with a USB port.
The receiver is attached to a mounting clip on the notebook's carrying strap
for mobile use.
The RX 300 also features a rubberised magnet for use with
a measuring vehicle. This holds the receiver on the roof of the vehicle
without damaging the paintwork - no need for the installation of a roof
antenna.
An LED control lamp continually indicates the status of the RX 300. |
|
The Software |
|
- Database-based software, no more cumbersome searching through folders
for file names, test can be seen at a glance
- Can also be run on 64-bit operating systems thanks to .net 2.0, future-proof
- Mode of curve of correlatable, synchronous data on a time axis with
free selection of correlation section; loud areas and areas with interference
can thus be reliably identified and hidden (e.g. times with noises of
consumption)
- Original noises can be recorded; there is the option of creating a
noise archive for comparison purposes or to allow other users work with
the stored leak noises post correlation
- Filters of up to 10 tapes in up to 5 filter groups; the results of
various, arbitrary filter settings can be compared
- Input up to 5 different pipe sections and up to 3 freely definable
extra materials; optimal flexibility as opposed to fixed standards for
correlation professionals
- Easy drawing of damage sketches to supplement measurement reports;
optimal documentation for service companies
|
|
System requirements |
| |
- Pentium 4 processor with 1.2 GHz minimum (1.8 GHz recommended)
- Minimum 512 MB DDR (recommended 1024 MB)
- Windows 2000 SP4, XP32/64 SP2, Vista 32/64
- Sound card
- Graphics card
- Minimum screen resolution 1024 x 768 pixels
|
| |
Technical Data -Transmitter RT 300 |
|
- Weight: 2.6 kg (incl. batteries)
- Dimensions (Ø x H): 110 x 215 (315) mm (excl./incl. antenna)
- Power supply: Rechargeable or disposable batteries (4 x D-cell mono
1.5 V)
- Operating time: Disposable: > 25 h; rechargeable up to 20 h (depending
on type of battery)
- Operating temperature: -10 °C … +40 °C
- Storage temperature: -20 °C … +60 °C
- Charging time: 3 h ... 7 h (depending on type of battery)
- Type of protection: IP64
- Housing material: Aluminium
- Connections: 3 sturdy, non-twist sockets for:
- charging/external power source
- Microphone
- Headphones(6.3 mm phone jack stereo)
- Processor: DSP with 24-bit signal processing, microcontroller-controlled
data processing
- Data memory: 32 MB signal memory (40 minutes)
- Radio: 1,88 GHz ... 1,9 GHz (bidirectional/DECT/250 mW)
- Carrying system: 3-point Tenax connection for attaching carrying handle
in 2 positions
- Mounting: Quick-connect for tripod
|
|
Technical data RX300 |
|
- Weight: 500 g
- Dimensions (W x H x D): 108 x 50 x 51 mm
- Power supply: External via USB
- Operating temperature: -10 °C … +40 °C
- Storage temperature: -20 °C … +60 °C
- Type of protection: IP68
- Housing material: Aluminium diecast
- Connection: USB 1.1 and higher, sturdy, non-twist socket (power consumption:
500 mA)
- Cable length: 2.9 m
- Radio: 1.88 GHz ... 1.9 GHz (bidirectional/DECT/250 mW)
- Rubberised magnetic attachment
- Mounting clip
|
|
Technical data EM3 300 microphone |
|
- Weight: 1.1 kg (incl. set of cables)
- Dimensions (W x H): 45 x 150 mm
- Operating temperature: -20 °C ... +80 °C
- Storage temperature: -30 °C ... +90 °C
- Type of protection: IP68
- Housing material: Stainless steel
- Cable length: 2.8 m
- Signal processing: ADC with 2 x 24 bit (digital microphone)
- Frequency bandwidth: 0 Hz ... 5000 Hz
- Light: Integrated high performance halogen diodes; enable easy installation
in valve boxes
- Connection: Horseshoe magnet, round magnet, various accessories
|
|
System case
Carrying case
Tripod
Chargers
Microphone EM 300
Radio transmitter RT 300
Receiver RX 300 with mounting clip |
